Violet Wand Roll Guard - Bdsm Toy Dominant Sadist attachment kink kinky

We've all done it, you set your wand down on a table, move over to take care of something or check in with subbie, and a voice in your head says "Nice wand... Be a shame if somethin' was to happen to it." Nice round case, round like a wheel. Wheels roll. And then there's that nice electrode, made of glass.

TV announcer voice "DONT LET THIS HAPPEN TO YOU!" :)

The casings of the BD-10 and similar rebranded wands are made of a rather brittle plastic which resembles bakelite. It's not particularly impact resistant. Or tolerant.. It tends to go BANG and shatter when it drops. Not fun at all, and pretty expensive. Just the replacement casing halves cost a lot, and then if you've damaged any of the guts, you might as well figure on a new wand.

The Roll Guard is a plastic collar that slides onto the top half of your wand, and encourages it not to roll by the simple fact of not being round! It also lifts up the wand a bit, protecting that side switch if you happen to have the BD-10AS model like I do.

This is fully compatible with my Wand Tripod Mount, you can use both at the same time.

This ONLY fits BD-10A and AS wands and the several re-branded versions like Huse etc. It will not fit any solid state wand that I know of. If your wand looks like the one in the picture, it will work. Wand case sizes vary, so yours may be a snug fit a bit higher on the wand, or it may need a little tape under the roll guard for a snug fit. That's something I can't control. E-6000 adhesive works well for a more permanent-ish but removable installation.

Available in various colors . Indicate your preference in a message when you order, otherwise I will choose.

To combine shipping, put all your items in your cart, and then check out.

Check my Fetlife profile for pictures of electrodes I have made.